Corvette Logo Light Box

Just another light box. I like the way they look, so I tend to make a lot of them. While I've made a lot of light boxes, I haven't started uploading models until recently. So, if I get something wrong, take it easy on me. ;-) As with my other models, I printed this with Bambu PLA Basic. All of the settings in the print profile are for that filament. One important note: When printing the boxes, and the stand, you'll get better results if you change the flow ratio back to it's original setting of 0.98…. I set it to 1.04 so that I could print the faces without any pinholes. You will need 8 3mm screws and nuts to assemble the model. I needed to split it up into several pieces to get the size I was hoping for. You will also need LED strips of your choice, and if you want to do what I did and use a USB C connector, then you'll need the following: https://www.amazon.com/DWEII-Chassis-Waterproof-Extension-Connector/dp/B0C7CPYL79/ref=sr_1_3?crid=3E10V5WR4MJXY&dib=eyJ2IjoiMSJ