MakerWorld
Other House Models
Go to Model
Counter top Ice Maker Modification Pins
1
Downloads
2
Likes
0
Makes
After following this youtubers guide to modify the top so you can clean it easier I decided to make the screws and 3d print them instead of buying and cutting some. https://www.youtube.com/watch?v=KvLcEqUvO0o Print 4x of them, ideally one at a time as it will make a more solid print, tear the brim off and then thread them in the holes by hand and they will act as the pins so the top will be easily removable when cleaning is needed.## Dont worry if very top of thread is rough its just to help it get started ##
ssweat also publishes on
10 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!