Thingiverse
Countersink Handle
door senns
70
Downloads
50
Likes
0
Makes
This is my Handel design for Countersinks it is easy to use and has a good strength holding everything with a 10mm shaft (added 1/4" shaft).
I printed the Mainbody and Tightener-screw with 90% and the shell with 100% infill.
All parts are printed with a layer height of 0,15.
Maybe you will need a brim for the Mainbody.
I chose PET-G Filament becouse of the good layer adhesion.
I printed the Mainbody and Tightener-screw with 90% and the shell with 100% infill.
All parts are printed with a layer height of 0,15.
Maybe you will need a brim for the Mainbody.
I chose PET-G Filament becouse of the good layer adhesion.
senns publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!