Counterswirl Top

Now, there's a new generation of this design: [Counterswirl Top - Generation 2](https://www.thingiverse.com/thing:6050411).

**Want to show off your top? Download my [Display Stand for Tops](https://www.thingiverse.com/thing:6094353). It prints in as little as 10 minutes!**

###Resizing

I've experimented with printing this and a few other of my tops at different sizes. I find this one spins consistently well at 100%. At 85% and at 70%, it spins well with a gentle spin, but some prints spin erratically if you spin them with more enthusiasm. They all seem to be aligned right with a clean tip. So, I'm guessing alignment is just more sensitive at the smaller sizes for this design.

I've updated my 3MF files to reduce the Elephant Foot Compensation from 0.2 mm to 0.05 mm. This has done a lot to diminish the visible seam between the two pieces. As always results will vary based on the usual suspects: your individual printer, the filament you use, and all your other settings.

If y