Thingiverse
Cover for PSG9080 Bluetooth Module
von Xruss
0
Downloads
2
Likes
0
Makes
Case for protecting the Bluetooth module of the signal generator.
The LED hole is filled with hot glue from a hot glue gun. From the inside of the module, we place a gasket to cover the hole. Then, we place a drop of hot glue into the hole from the outside and smooth it with a wet finger, removing any excess hot glue.
The LED hole is filled with hot glue from a hot glue gun. From the inside of the module, we place a gasket to cover the hole. Then, we place a drop of hot glue into the hole from the outside and smooth it with a wet finger, removing any excess hot glue.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
