Cover for Rotary Encoder base.

Hi. This is a cover for a standard EC-11 Rotary encoder base, mainly just for aesthetics. I was building a keyboard, and wanted to make the base less conspicuous, so designed this simple cover that slides over the shaft and is held in place by the mounting nut.

Printed top side down, at .12 resolution, no supports, without a raft or brim, at 40mm/s on an Ender 3 Pro. Took less than 20 minutes each using PLA.

The v1.1 is for a standard encoder, and is symmetrical on both axis.

The 'Trail Mix' versions were for a prototype keyboard built by RainKeebs, and are specific to that board, but may be modified to use with other applications. https://www.etsy.com/ca/shop/rainkeebs )