Thingiverse
Covid-19 Face shield for small printer.
by kevin_clyne
24
Downloads
29
Likes
0
Makes
Based on the design of 3DVERKSTAN.
Divided in half to fit on a 6"x 6" print bed.
small amount of trimming on the two part that slides together, just to remove supports.
for the clear part
Office Depot Item 459-207
Must be GLOSSY CLEAR.
Use a US standard 3-hole punch, punch long edge in the center then move the sheet left or right in the hole puncher until previous holes are centered between the punchers pins and punch again.
Divided in half to fit on a 6"x 6" print bed.
small amount of trimming on the two part that slides together, just to remove supports.
for the clear part
Office Depot Item 459-207
Must be GLOSSY CLEAR.
Use a US standard 3-hole punch, punch long edge in the center then move the sheet left or right in the hole puncher until previous holes are centered between the punchers pins and punch again.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
