Thingiverse
Covid-19 protective shield
von jf3d
4
Downloads
4
Likes
0
Makes
Easy to print face shield. You need a A4 size transparent film and a piece of elastic band. Can be printed on small (150x150 cm) printer.
Use a standard hole punch (8 cm between holes).
Printing time : 35 mn on Flashforge Finder (coarse).
A new version is proposed. This version is easier to print.
New again : version 6
It's even more easier to print. Spheres are replaced by cubes in the design.
Has been succesfully printed on Flashforge finder, Ultimaker original, Ultimaker 2+ extended, Dagoma Neva, and Crealty cr-10 s.
Use a standard hole punch (8 cm between holes).
Printing time : 35 mn on Flashforge Finder (coarse).
A new version is proposed. This version is easier to print.
New again : version 6
It's even more easier to print. Spheres are replaced by cubes in the design.
Has been succesfully printed on Flashforge finder, Ultimaker original, Ultimaker 2+ extended, Dagoma Neva, and Crealty cr-10 s.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
