Thingiverse
COVID blaster 99.99%
von CreamOfPantSoup
38
Downloads
41
Likes
1
Makes
There should be a "Yes-ish" option for supports.
I designed and perfected this under the infuence of alcohole. I am writing this under the influence on alcohol. Nailed it.
Print this b**** however you want, it's still gonna be sick and keep you from getting sick.
Realistically, .2 LH worked well for all parts.
(If you're not using Cura. I don't know your language so figure it out)
Print the BODY thread, or "muzzle" up with supports from the build plate ONLY.
If you select "everywhere" you will f*** yourself.
The trigger should be printed on it's side. Because expediency. It's faster this way. Print it on it's side with supports EVERYWHERE. Mint.
BTW enable support interface, stop hurting yourself.
Print the THING in any way you want. But you'd be an idiot if you printed it without the chamfered end up. You'll have to chuck it up in a drill and give it a nice concentric point (rounded or not) with sand paper or something abrasive.
You'll need a pen spring by
I designed and perfected this under the infuence of alcohole. I am writing this under the influence on alcohol. Nailed it.
Print this b**** however you want, it's still gonna be sick and keep you from getting sick.
Realistically, .2 LH worked well for all parts.
(If you're not using Cura. I don't know your language so figure it out)
Print the BODY thread, or "muzzle" up with supports from the build plate ONLY.
If you select "everywhere" you will f*** yourself.
The trigger should be printed on it's side. Because expediency. It's faster this way. Print it on it's side with supports EVERYWHERE. Mint.
BTW enable support interface, stop hurting yourself.
Print the THING in any way you want. But you'd be an idiot if you printed it without the chamfered end up. You'll have to chuck it up in a drill and give it a nice concentric point (rounded or not) with sand paper or something abrasive.
You'll need a pen spring by
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!