Thingiverse
Covid Card Multipass
von tmigratorius
1
Downloads
1
Likes
0
Makes
Remixed Covid Card sized multipass, prints in one piece.
this has to be print VERTICAL with supports. round end down, card slot up
I used a brim and tree supports generated in cura slicer
the slot is small enough that the card will not fall out on accident but must be violently shaken to dislodge it
this has to be print VERTICAL with supports. round end down, card slot up
I used a brim and tree supports generated in cura slicer
the slot is small enough that the card will not fall out on accident but must be violently shaken to dislodge it
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!