Thingiverse
Cowboy Bebop USD Drive
von Chalter
76
Downloads
83
Likes
1
Makes
This remix made the Bebop into a USB drive holder. The tail fins have been made thicker so that the model prints better.
You can choose between The Bebop or the Swordfish II
The USB drive opening is approximately 6mm X 14mm, with an enclosed length of 20mm. The models are not exact since it had to be modified to print at this small scale.
You can choose between The Bebop or the Swordfish II
The USB drive opening is approximately 6mm X 14mm, with an enclosed length of 20mm. The models are not exact since it had to be modified to print at this small scale.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
