Thingiverse
Cowry (Cowrie) Shell
por viper1990
60
Descargas
60
Likes
1
Makes
69 Photoshots around the model of this Cowry (Cowrie) shell picked from the beach.
This model has 180,000+ Mesh Faces, recommended to slow your printer speed to get the most detail out of it (perhaps 40mm-60mm/s for infills and perimeters)
The shell is all rounded on every sides, to print with smooth details. Either:
1) Use dis-solvable filaments as supports
2) Slice the shell into half and glue the 2 pieces together when printed out
3) Use the normal way of using supports/pillars to form an artifical base. (Note that the surface might be rough when the support breaks away, use a 400 gritt sandpaper to sand it down to level)
This model has 180,000+ Mesh Faces, recommended to slow your printer speed to get the most detail out of it (perhaps 40mm-60mm/s for infills and perimeters)
The shell is all rounded on every sides, to print with smooth details. Either:
1) Use dis-solvable filaments as supports
2) Slice the shell into half and glue the 2 pieces together when printed out
3) Use the normal way of using supports/pillars to form an artifical base. (Note that the surface might be rough when the support breaks away, use a 400 gritt sandpaper to sand it down to level)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!