CP2112 USB C Case

3D Printed Enclosure for CP2112 ModuleDescription:A two-part enclosure designed to securely house the CP2112 HID USB to SMBus/I2C master bridge module. The design includes precise cutouts for the USB connector, pin headers.Material: PET-G (recommended for potential heat resistance).Nozzle: 0.2mm (for finer details and smoother surfaces).Hardware: 2x M3x10 countersunk screws required for assembly.Assembly Instructions:Insert the CP2112 module into the main base.Position the cover at an slight angle, first sliding the cover pins into the corresponding holes in the base above and below the O/I module pins.Hinge the cover downward (like a latch) until it fully go into the base.Secure the enclosure by tightening the two M3x8 countersunk screws through the top cover into the base.Notes:Ensure screw holes are cleared of support material post-printing.Designed for snug fit; no additional fasteners required.