CPG Display Case 2.0

This is the 2.0 release of my design for a display case for models and miniatures, incorporating a track to hold LEDs and a cut out to feed the cable behind the box. The shelves and front from the original are interchangeable (the front actually didn't change at all) An AMS is not required for this as each build plate is in 1 colour, and construction is relatively straight forward and apart from glue you will need 8 5mmx2mm magnets to hold the door in place, a clear Perspex sheet 2mm thick and 188 mm square. The parts go together as per the below diagram: The front of the cover has a lip to hold the Perspex window, the back of the cover has 8 pins for alignment, simply glue in place holding the sheet of acrylic.There are 4 magnet holes on the back of the front cover - I have found the a bit of gentle force and friction will hold the magnets in place, similarly the main body has matching holes for magnets, again friction will hold these, just make sure to get the polarity correct so