Thingiverse
CR-10 Cable Protector
von SvdSinner
26
Downloads
12
Likes
0
Makes
This is a small shield to prevent the USB cable from getting knocked out while reaching around to the power switch.
Simply hot glue the part to the side of the CR-10 over the USB port. If you need additional hold, you can use a rubber band or zip tie on the tabs to secure the cable.
Now, no more connection problems from knocking the cable! :)
Simply hot glue the part to the side of the CR-10 over the USB port. If you need additional hold, you can use a rubber band or zip tie on the tabs to secure the cable.
Now, no more connection problems from knocking the cable! :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!