CR-10 Connector Bracket

Cornely_Cool made an amazing CR-10 enclosure and included brackets to connect the printer and the base from the outside, but I didn't like the look of it. I designed a bracket to connect the two parts from the inside and so far it works perfectly! I put no tolerances into my design to make it a tight fit. I had to use a clamp to push the two halves together.

Extra Materials:
- M4 T slot sliding nut (x20 at most)
- M4-.70 x 12mm screws (x20 at most)

I put these on after I assembled the base, so there were some screws I couldn't get to, so I ended up only using 18 of each.

The cut-bracket piece is for the back left corner, and I made it that way to not cover the vents. I don't believe it compromises much of its integrity.