CR-10 Controller Knob

There was nothing wrong with the stock controller knob, I just wanted to replace it for looks. It is a pretty simple design. I did use supports to print it If you are using Simplyfi3d or other slicer that allows you to remove supports from certain areas I suggest you remove all the supports that may be generated in the center area of the design. They were a bit hard to remove in the small spaces and really not required since the "bridge" is so small.

I am guessing this will fit other printers besides the CR10. Fit was good, not so tight it required a mass amount of force to put on, and not so loose that it did not function right.