CR-10 Integrated

This is an integration of the CR-10 control box under the printer.

It includes an mount for an integrated Raspberry PI (for Octoprint) and a power relay.

I recommend printing at 0.3 layer height as a compromised between incredibly long print times and good quality.

You don't need any extra fans or wires for this. You can pretty much remove the hardware from the control box an install in the mounts. In order to remove and re-install the two case fans, you will need to cut their power wires and re-connect them. There is enough slack in the wires to support any connection method. I used JCY connectors, which I crimped, but you could also solder them or use terminal blocks.

You will need extra t-slot nuts to mount the cases to the CR-10 frame.

I do not use the SD-Card, but if you do, you will need an SD-Card extender. (There is a cut-out in the case for the display ribbon cable, which you can also use for the SD-Card extender cable.

I recommend loosely passing the cables