CR-10 Light Bar IKEA Hack

Simple light bar for CR-10. Uses an inexpensive Ikea Dioder light bar kit.

Snap and interference fit. Used electrical tape to hold the light bars in place for the photo, but should use double sided tape or hot glue or clip if you want to design one (elec tape works fine though).

The standoffs provide plenty of room to keep the full 400mm Z travel.

I hid the power wire under the orange trim piece (I removed the trim from the front uprights and re-purposed)

Dioder is soft white, so may not be bright enough for everyone. You can simply print a mounting plate and install in place of Dioders and tape/glue any led light ribbon you want (I did not include a design for this).