CR-10 Mini Semi Auto Leveling G-Code

Download and run the CR-10 Mini Semi Auto Leveling Code.gcode file

Be ready with your paper so you can set it in place before it hits Z0 at each corner.

This is a Semi Auto Leveling procedure for the Creality CR-10 Mini.
It will go to the home position and then to all four corners () and wait 15 seconds while you make the adjustment to each leveling wheel with your test gauge paper. The printer will beep 3 times before each move so you are not caught with your fingers in the wrong place at the wrong time :-). 3 quick beeps when the procedure is complete.

I like to heat the bed before leveling. The G-code has the heat disabled by default.
Uncomment it in the G-code if you want to use heat before leveling. The procedure will wait for the bed to achieve to set temperature before continuing.

BTW. If you ever take the cover off the controller, put a few layers of tape over the speaker hole. REALLY knocks down the squeal of those beeps.

WARNING!
Your bed should ALREADY be