Thingiverse
CR-10 Mosfet Model
7
Downloads
4
Likes
0
Makes
Not for printing. This is a model of the Creality CR-10 bed mosfet. It may be the same or similar to mosfets in other Creality printers and clones.
Use this to aid in designing mounts and cases.
Enjoy!
Note- I noticed I forgot to add the leads on the bottom side of the board. I'll add them soon. Until then, allow some clearance under the mosfet, connector, and screw terminals.
Use this to aid in designing mounts and cases.
Enjoy!
Note- I noticed I forgot to add the leads on the bottom side of the board. I'll add them soon. Until then, allow some clearance under the mosfet, connector, and screw terminals.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!