Thingiverse
CR-10 Printer Legs
von thekokiko
90
Downloads
38
Likes
0
Makes
Legs for CR-10 3D Printer
Raises the base 160mm to allow room for control box to fit underneath
Will need to move spool position. Will not fit on top of control box anymore.
May require slight shimming depending on settings.
If you try them out. Please leave feedback. Thank you
Raises the base 160mm to allow room for control box to fit underneath
Will need to move spool position. Will not fit on top of control box anymore.
May require slight shimming depending on settings.
If you try them out. Please leave feedback. Thank you
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!