CR-10 spool holder

This is a remix of DigChaos' mount. I wanted the spool to ride on the bearings directly.
Parts:
* 2 male sides
* 2 female sides
* 4 bearings
* glue
* sandpaper
* clamps / tape

You will need to print 2 of each (2 male and 2 female).
Sand bearing posts and test fit bearings
Place 2 bearings on the female side
Add small dabs of glue on the female side and combine with the male side.
(There is one image that shows where I put glue on mine)
Clamp or tape the 2 halves together according to your glue directions.

Repeat the above for the second set.

You don't need this level of bearing, but this is what I had and used:
https://www.amazon.com/dp/B000FDRQ1S

I use clear Gorilla Glue for my projects:
https://www.amazon.com/dp/B06WD6R96X