Thingiverse
CR-10s Bed Leveler
von emptykay
10
Downloads
8
Likes
0
Makes
A Leveling Test for a 300x300 Bed. Originally thingied for a Creality CR-10s.
While printing, the hotend should leave behind a single line.
Adjust the bed height while it is printing. While adjusting, lightly brush the printed line with your finger. If it does not come off the bed, that area of the bed is level.
It is hard to get a large bed that is 100% level because of the bed warping - it is recommended to focus on the leveling of your print region instead of the entire bed.
It is also recommended to install a Automatic Bed Leveler, and use this test to check its accuracy. Generally, installing an ABL is highly recommended.
While printing, the hotend should leave behind a single line.
Adjust the bed height while it is printing. While adjusting, lightly brush the printed line with your finger. If it does not come off the bed, that area of the bed is level.
It is hard to get a large bed that is 100% level because of the bed warping - it is recommended to focus on the leveling of your print region instead of the entire bed.
It is also recommended to install a Automatic Bed Leveler, and use this test to check its accuracy. Generally, installing an ABL is highly recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!