CR-10S Control Box Stand

This is a stand for a CR-10S control box. All builds require the front and rear base. The short legs raise the box 50mm and the tall legs lift the control box 150mm.

I built a custom wire harness so I could connect both 40mm blowers to the same fan connector on the CR-10S v2.2 motherboard.

The build requires the items listed below. However, the length of the M2 screws could be shortened. I used what I had on hand.
- 11 M2 x 16mm screws and 11 M2 nuts: https://www.amazon.com/dp/B07W5J4WC9/ref=cm_sw_em_r_mt_dp_U_uEu5EbJ6QPY82
- 8 M5 x 12mm: https://www.amazon.com/dp/B019ETJWEC/ref=cm_sw_em_r_mt_dp_U_ywu5EbFMGESV0 - 8 M5 - T-nuts: https://www.amazon.com/dp/B07SDD7PNN/ref=cm_sw_em_r_mt_dp_U_ICu5EbRWBT9EQ
- 2 40x10 blowers: https://www.amazon.com/dp/B07RNZF97F/ref=cm_sw_em_r_mt_dp_U_LJu5EbKVRMJ6V