CR-200B endoscope mount

I liked Krux66 mounting idea. I measured it for mounting on the CR-200B without the metal shroud cage.
In the picture, I mounted using the angled version which allows a view a little from above. I've included the flat version where it will provide a flatter view giving you a better indication of how high each layer is printed.
The finger allows you to tuck the wire neatly back and out of the way.
I mounted on the left side but if you need to mount on the right, you can mirror it. If you need me to mirror, just message me.
This setup does not interfere with the print path.
2021/12/07 Update: original design did not play nice with the heatblock. It was too close and started to deform it. Change to mounting it on the outside of the fan.
2021/12/09 Final Update: the angle was great. I flattened to only 10 degrees. You chose whichever you prefer
NOTE, my picture I have the endoscope mount on the left since my 5015 fan duct tucks real nice under the chassis and with some slight altera