Thingiverse
CR-30 Wall Hook.
by TiDup
0
Downloads
1
Likes
0
Makes
Moved to CULT3D.com
Printed in PLA, 95% infill.
Screwed on my wall on a good wood backing (1/2in, but rather take 3/4 if i had on my hand). 4 screw were enoug and my printer is still on the wall. You can tap the top hole and design your own lock (M6 thread ready).
No need to modify anything from the printer. Just be carefull of the wire. You can squize shingle under the foot of the printer (or scale it screw direction only) If the wall is crocked or uneven.
Mesure & level twice, screw once. I left 6mm shorter outlined of the 2 hook.
Double tape help.
Printed in PLA, 95% infill.
Screwed on my wall on a good wood backing (1/2in, but rather take 3/4 if i had on my hand). 4 screw were enoug and my printer is still on the wall. You can tap the top hole and design your own lock (M6 thread ready).
No need to modify anything from the printer. Just be carefull of the wire. You can squize shingle under the foot of the printer (or scale it screw direction only) If the wall is crocked or uneven.
Mesure & level twice, screw once. I left 6mm shorter outlined of the 2 hook.
Double tape help.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!