Thingiverse
CR10 Bed Leveling Calibration
por TeepsDeluxe
37
Descargas
11
Likes
0
Makes
## A decent check for auto bed-leveling on the CR10
I recently installed a BLTouch sensor on my bed.
>> [More info here.](https://docs.cbteeple.com/3d_printing/upgrades)
I needed a way to evaluate the z-probe offset after leveling, but I couldn't find a good test for auto bed leveling, so I made my own. It's especially important on the CR-10 since the bed is so large. This is based on the Prusa first layer calibration routine with a zig-zag across the whole bed, then a small square to test perimeter adhesion.
I recently installed a BLTouch sensor on my bed.
>> [More info here.](https://docs.cbteeple.com/3d_printing/upgrades)
I needed a way to evaluate the z-probe offset after leveling, but I couldn't find a good test for auto bed leveling, so I made my own. It's especially important on the CR-10 since the bed is so large. This is based on the Prusa first layer calibration routine with a zig-zag across the whole bed, then a small square to test perimeter adhesion.
TeepsDeluxe también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
