Thingiverse

CR10 Cable Spool holder

von Bikerjoy

9 Downloads

4 Likes

0 Makes

Ball bearing spool holder to CR10-S control box. Same as my Prusa spool holder this one lowers center of gravity and shorter pivot, greatly reducing vibrations and oscillations on the table. Also allows use of wider spool that the CR-10 stock shaft would not. For instance the Prusament spools are too wide to use with the stock holder.

Needs 4x 8x16x5mm Ball bearings and 4 M3 screws to complete.

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat