CR10 filament guide

Remixed bowden drive sensor with arm for a wheel to guide the filament. The high pitched squeaky noise the printer (filament and/or extruder?) emits when moving the filament was resolved with this.

You can use the original filament guide that comes with the CR10S and put this one under it (2mm longer screws would be nice if you have them). Each wheel attachement needs a 608 bearing and an m3x20 + bolt.

Updated with a two wheel version for better alignment.

The wheel was remixed (enlarged) from a removed spool holder by Gavitka (thing:2491574), small wheel untouched.

Get the lid here: https://www.thingiverse.com/thing:2770180

Made with Tinkercad, edit the design here: https://www.tinkercad.com/things/jqaVmz3HFlz