CR10 Smart Auto Bed Level

I've got firmware version 1.0.10 (Waiting an open source code from Creality!!!)
hardware version CRC2405V1.2
I've recently connect my octoprint to my CR10-Smart...
If you couldn't please check the link below.

https://damsteen.nl/blog/2021/04/24/connect-creality-cr-10-to-computer-or-octopi

I'm using these commands one after each other from the terminal. (or now then I uploaded the gcode for you to make it easier without connection to terminal etc.)


M190 S65 ; Heat bed to 65 degrees celsius
M104 S210 ; Heat nozzle to 210 degrees celcius which is not really needed
G28 ; Home XYZ.
G29 ; Do automated probing of the bed.
M500 ;Save current setup.

I cannot achieve an even, good first levet at all with this settings... If you do please make a comment
I've reset the EPPROM and reload a new fresh one with the magic M420 S1 ;re-enable bed leveling command... tadaaaa everything working properly.

The below code is my start