Thingiverse
CR10 V3 FILAMENT SENSOR SUPPORT
door mkdir_3d
5
Downloads
1
Likes
0
Makes
With the CR10 V3 printer I have had several problems when placing the filament and printing, using the filament sensor.
In large pieces, the filament takes shapes that produce an excess of tension (by having the factory support at the same height as the spool support).
For this reason, I have designed this piece that would go next to the coil support. I have reduced the height to a minimum and used the screws that come from the factory, reducing the tension in the thread. Also, it will not affect the maximum height of the machine.
You'll need:
* 4xM3x10mm nuts (The screws are the ones that come from the factory. you will need nuts)
In large pieces, the filament takes shapes that produce an excess of tension (by having the factory support at the same height as the spool support).
For this reason, I have designed this piece that would go next to the coil support. I have reduced the height to a minimum and used the screws that come from the factory, reducing the tension in the thread. Also, it will not affect the maximum height of the machine.
You'll need:
* 4xM3x10mm nuts (The screws are the ones that come from the factory. you will need nuts)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!