Thingiverse
CR10S Filament Guide
by NoSeams024
12
Downloads
6
Likes
0
Makes
Designed to ease the angle of attack for where the filament enters the filament runout sensor on the CR10S Pro v2.
Requires one 3/8" OD X .171 ID X 1/4" WIDTH nylon spacer, and one 8/32" thread x 3/4" length screw.
Press the spacer into the center hole on the pully, and attach to the mount with the 8/32 screw.
Requires one 3/8" OD X .171 ID X 1/4" WIDTH nylon spacer, and one 8/32" thread x 3/4" length screw.
Press the spacer into the center hole on the pully, and attach to the mount with the 8/32 screw.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
