Cr10s Pro Direct drive bracket - Inductive Sensor

Remixed Lujes' DD mount for cr10s pro. Mirrored it (so it doesnt crush the inductive sensor wire, added a better support system (the bracket is now supported by the X carriage, and gave myself 10mm more wiggle room in the Capricorn tubing, used FARDO3d stepper motor extension (4 bucks) printed in PETG. print stepper motor side down, that way you dont have to use any supports.

using 2.5mm and 80mm/s retraction settings, still able to get about 60-65mm/s print speed without ghosting and basically eliminated all my stringing.

Basically a 4$ upgrade and so far prints waaaaaaaaaaay better, obviously i lost a little bit of print space on the Z axis, but i dont ever print that tall.

cr10s pro v1 - stock dual gear extruder, and stock hotend.