Cr10s Pro Support frame

I have used and tested for more than a year and not encountered any problems so far
But there are still two items that need attention

1.You may need to use a mallet when putting M12 nuts into objects
2.Because the iron plate at the bottom of the machine is soft
There may be tolerances between the low object and the machine base
It is recommended to use the first layer of the slicing software for fine-tuning

I have done all the printing using PLA and got the expected results
For better support, maybe you should use higher padding

You will need the following additional materials
M12 Screw thread At least 750MM *2
M12 Flange nut *8
M3 screw at least 8MM *4
M4 screw 8-9MM *4
2020 aluminum extruded T-slide nut *4


For Cr10spro & Cr-x