Thingiverse
CR10S Pro V2 Riser
von SebSydney
2
Downloads
1
Likes
0
Makes
I created these to allow me to run a 120mm fan under my CR10S Pro V2
The fan in the PSUY is rediculously loud, and now it runs really quietly. These feet allow you to lift the printer by an additional 20mm which combined with the original rubber feet means the printer sits 35mm above the surface allowing 15mm for airflow under the fan.
The rubber feet slide nicely into the insert. You can use a 35mm M4 screw to connect the feet to the bottom of the printer using the original holes. No drilling or adjustment required. Alternately, screw just the printed feet in an superglue the rubber feet in place afterward
The fan in the PSUY is rediculously loud, and now it runs really quietly. These feet allow you to lift the printer by an additional 20mm which combined with the original rubber feet means the printer sits 35mm above the surface allowing 15mm for airflow under the fan.
The rubber feet slide nicely into the insert. You can use a 35mm M4 screw to connect the feet to the bottom of the printer using the original holes. No drilling or adjustment required. Alternately, screw just the printed feet in an superglue the rubber feet in place afterward
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
