Thingiverse
CR6 Raspberry Pi Case
von bollekeil
24
Downloads
9
Likes
0
Makes
It's a Remix of https://www.thingiverse.com/thing:3090773
I changed the design so that it fits perfectly on a Creality CR 6-SE. I enlarged the hole on the SD card so that you could easily take it out. As an alternative, I have attached a cable holder for a Pi-Cam so that it is not accidentally pulled from the bed.
Support is only needed on the bracket. The cable holder can also be printed without.
Even after several hours of printing, I never had any problems with PLA.
CR 6 PiCam Holder: https://www.thingiverse.com/thing:4842559
I changed the design so that it fits perfectly on a Creality CR 6-SE. I enlarged the hole on the SD card so that you could easily take it out. As an alternative, I have attached a cable holder for a Pi-Cam so that it is not accidentally pulled from the bed.
Support is only needed on the bracket. The cable holder can also be printed without.
Even after several hours of printing, I never had any problems with PLA.
CR 6 PiCam Holder: https://www.thingiverse.com/thing:4842559
bollekeil veröffentlicht auch auf
17 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!