Thingiverse
Craftbot Flow IDEX Lid Holder
por Waggster
4
Descargas
2
Likes
0
Makes
I needed somewhere to put the lid when printing PLA to let the heat out. Designed up these simple lid holders that screw onto the frame. I used M3 x 10mm screws, one for each side.
Printed in ABS at 0.2m / 30% infill. Work a treat :-)
Printed in ABS at 0.2m / 30% infill. Work a treat :-)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!