Thingiverse
Craftsman Battery Mount
von qwiktune
67
Downloads
40
Likes
1
Makes
This is a wall/under shelf battery holder mount for the matching craftsman batteries. I have mounts for all my other (dewalt) batteries and wanted the same for my craftsman batteries. I believe there are a few lines this may work with, but I particularly made this to fit the standard size C3 19.2V Lithium-Ion Batteries.
*For the bigger sizes/XCP use the Wall Only versions since the "roof" of the original only has clearance for the smaller standard size.
*ADDED 1/22/19* Wall Only mount allowing fit of any size C3 battery.
*ADDED 1/22/19* Wall Only v2 with thicker arms and no text allowing to be printed flat horizontally on the plate with NO supports. +Rounded off edges.
*ADDED 1/23/19* Mini Version you drop the neck down through. No supports needed.
*Resolution* I was able to print at .25 when prototyping, but .2 is recommended for a cleaner look if that matters to you.
*Infill* 15-25% The higher the stronger the arms will be. Keep that in mind depending on the size
*For the bigger sizes/XCP use the Wall Only versions since the "roof" of the original only has clearance for the smaller standard size.
*ADDED 1/22/19* Wall Only mount allowing fit of any size C3 battery.
*ADDED 1/22/19* Wall Only v2 with thicker arms and no text allowing to be printed flat horizontally on the plate with NO supports. +Rounded off edges.
*ADDED 1/23/19* Mini Version you drop the neck down through. No supports needed.
*Resolution* I was able to print at .25 when prototyping, but .2 is recommended for a cleaner look if that matters to you.
*Infill* 15-25% The higher the stronger the arms will be. Keep that in mind depending on the size
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
