Thingiverse
Crazy Cogs - Gear Play Set
von papabravo
778
Downloads
598
Likes
1
Makes
I wanted to experiment with simple low-cost DC motors and see how easy it would be to make my own 3D designs to convert their high speed, low torque attributes into something more usable. So I designed this gear experiment set that lets you position and fix various gear sizes onto a matrix board. You can then drive the input with a commonly available DC motor or a crank handle option. I added a linear piston as an output device and also a spinning thing, but this is just a bit of a novelty.
https://www.youtube.com/watch?v=2tM8FO0YgnI
The gears have various diameters; 50, 45, 40, 35, 30, 25, 20 and 15 mm
All of them have a 10mm inner spindle gear.
The 8 x 8 cm matrix boards have M3 holes space at 5mm.
Use M3 x 20mm screws to hold the gears in place. I did try printing some 3mm pins for this but they are not so easy to print and were too weak. You can also print the stand-off feet the raise up the matrix boards to give space underneath for any excess screw length or if you
https://www.youtube.com/watch?v=2tM8FO0YgnI
The gears have various diameters; 50, 45, 40, 35, 30, 25, 20 and 15 mm
All of them have a 10mm inner spindle gear.
The 8 x 8 cm matrix boards have M3 holes space at 5mm.
Use M3 x 20mm screws to hold the gears in place. I did try printing some 3mm pins for this but they are not so easy to print and were too weak. You can also print the stand-off feet the raise up the matrix boards to give space underneath for any excess screw length or if you
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!