Thingiverse
Creality cr10s pro - Cable_guide
von EUCGUY
60
Downloads
35
Likes
0
Makes
Updated to fit.
Arm around the left-side z-motor, clamp fits into frame. To be mounted on the left side of the printe.
Is held in place on the printer itself. no glue needed. PLA will work fine.
Arm around the left-side z-motor, clamp fits into frame. To be mounted on the left side of the printe.
Is held in place on the printer itself. no glue needed. PLA will work fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
![CR10S Pro Spool Holder + Z Chain combo mount [Better Fit & Shorter remixes]](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fassets%2F83%2F86%2F79%2Fb3%2F44%2Flarge_display_2021-01-17_17_41_49-Photos.jpg&w=400&h=300)
