Creality CR10sProDuct

This is a Part Cooling Duct for the CR-10s Pro and does not require any modifications to the original design of the printer. It uses the existing 4020 Radial part cooling fan and will require 2 longer M3x20mm screws to mount.

Version History:

CrealityCR10sProDuctV1.stl Is the original part that I modeled.
CrealityCR10sProDuctV2.stl will be 1mm taller and will give 1mm additional clearance between the sock of the nozzle and the duct. To use this version the ABL and sensor may need to be adjusted to give more clearance during the 25 point ABL routine. You can adjust your Z-offset back down to the print surface using "live" leveling when the print starts.
CrealityCR10sProDuctV2.1.stl same as V2 except better design to distribute airflow from cooling fan.

The part should be printed as oriented and shown on the pictures using support only needed under the duct that raises up and runs right under the nozzle cooling fan return.

Thanks goes out to Baloubic's Original Design co