Thingiverse
Creality Ender 2 Pro
by maa_boo
21
Downloads
22
Likes
0
Makes
This is the dimensional model of Ender 2 Pro made by reverse engineering (manually measured) with some official parts from Ender 3.
**WARNING! DUE TO MANUAL MEASURMENT THERE ARE SOME INACCURACIES. PLEASE, ALLOW AT LEAST 0.5 mm OF CLEARANCE. ALSO, REPORT ME IF YOU FOUND ANY ERROR.**
Important notes
--------
* Parts were tested for parts mutual matchings and collisions and thus they are accurate to some extent, although I didn't print any parts (except https://www.printables.com/model/528496-beekoohaa-printhead-beta-for-creality-ender-2-pro-) to check physical matches and collisions.
* Due to complex geometry of the molded parts (and weird design) some of details like reinforcing ribs forming simple surface are omitted (actually they are converted to single block).
* Also, since I started to made this model after I cut my case, there are reinforcing ribs which has inaccurate size.
* Model doesn't have spool holder and tray.
* It also has very simplified screen and power sup
**WARNING! DUE TO MANUAL MEASURMENT THERE ARE SOME INACCURACIES. PLEASE, ALLOW AT LEAST 0.5 mm OF CLEARANCE. ALSO, REPORT ME IF YOU FOUND ANY ERROR.**
Important notes
--------
* Parts were tested for parts mutual matchings and collisions and thus they are accurate to some extent, although I didn't print any parts (except https://www.printables.com/model/528496-beekoohaa-printhead-beta-for-creality-ender-2-pro-) to check physical matches and collisions.
* Due to complex geometry of the molded parts (and weird design) some of details like reinforcing ribs forming simple surface are omitted (actually they are converted to single block).
* Also, since I started to made this model after I cut my case, there are reinforcing ribs which has inaccurate size.
* Model doesn't have spool holder and tray.
* It also has very simplified screen and power sup
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
