Creality Ender 3 alignment prints

Creality Ender alignment prints for digital gauge

These are the Companion models to this video: https://youtu.be/AN0MlQMMew0

Since the models are structural, but not particularly load-bearing, I printed the gauge holder in Cura with 0.32mm layers, 2 perimeters, 10% 'lines infill' with 'connect infill lines' enabled. The tips were printed with stock 0.28mm quality setting (or maybe it was Chep's "Magic 0.28" setting... I don't remember).

The gauge used is at this link https://amzn.to/32ru63D

If you want to make it spring-loaded, you can slip a pen spring over the gauge shaft before pressing the tip on (there is a lot of friction in the gauge though, so it should be a pretty stiff spring).