Creality ender 3 spool holder

Modeled using measurements from my actual bull bar! I tried to get it as close as possible, but added frame mounting and provisions for a Warn-licensed 1:10 scale winch. Uses the RC4WD cable rollers.

Tolerances are designed in, so print at 100% scale and make sure your extruder is calibrated.

I still plan on adding some sort of bracket to mount the hardbody to.

OBS!This filement spool holder only works for smal filement rolls with at maximum witdh of 55mm (2.165 inches.)

The diameter of the filements center hole shouldn't extend over 17,5mm (0.69 inches.)