Thingiverse
Creality Ender 5 S1 Accelerometer Mount
by jbfueston
0
Downloads
0
Likes
0
Makes
Rigid mount for input shaping calibration using BigTreeTech ADXL345 accelerometer board
Installation:
Attach accelerometer to mount using included screw and large center hole. Remove heatbreak fan, screws, and spacers. Reinstall heatbreak fan with mount in place of factory spacers.
Be sure to set y, -x, z as accelerometer axes in klipper config file.
Supports may not be necessary depending on your setup but worked better for me with them enabled.
Installation:
Attach accelerometer to mount using included screw and large center hole. Remove heatbreak fan, screws, and spacers. Reinstall heatbreak fan with mount in place of factory spacers.
Be sure to set y, -x, z as accelerometer axes in klipper config file.
Supports may not be necessary depending on your setup but worked better for me with them enabled.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!