Creality Falcon Honeycomb alignment brackets

I battled to be able to perfectly align my Falcon laser printer to do accurate cuts and engraving. The following has worked very very well for me

Prep base wood:
You will need a base MDF or similar to mount the 4 units onto using regular wood screws, I used 10mm screws. To get the best results you should design a square using the work area dimension of your honeycomb in Lightburn, in my case this was 300x300 and I started this at the 0;0 origin (X;Y) however you can decide where you want to put this, bearing in mind that what ever you design within LightBurn will then need to be positioned within this 'work area', I found the origin point the most logical.

Prior to any installation burn these lines directly onto the MDF, this will provide you the real reference lines to align your honeycomb to the work area. Make sure you use a high enough power/speed to easily see the lines.

Print files:
I used standard PLA with PLA settings, I printed the 4 supports in one print, not supports need