Thingiverse
Creality Filament Guide
door AndrewCharlton
16
Downloads
13
Likes
1
Makes
I remixed this handy accessory by MattEllison to have a notch cut out.
I found it slightly more convenient and the position of it doesn't allow the filament to dislodge itself.
Rather than winding up the filament through the hole, now simply pull to the side to remove.
I found it slightly more convenient and the position of it doesn't allow the filament to dislodge itself.
Rather than winding up the filament through the hole, now simply pull to the side to remove.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
