MakerWorld
3D Printer Parts
Zum Modell
Creality K1 Max Side Braces
50
Downloads
18
Likes
2
Makes
I made these braces to strengthen the frame in the K1 Max 3D printer.From my previous versions I found out the panel likes to rattle against the printed part in the areas between the screws. You will need 1mm foam tape to prevent the panel rattling on the plastic (pictured) Needed:M3x4x5 Heat InsertsM3x12mm BHCS ScrewsM3x20mm Screws1mm thick foam tape If you like my work consider buying me a ko-fi ☕😊 Your support is greatly appreciated.Last Updated: Aug 23, 2024github
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!