Thingiverse
Creality Pulley Puller
door GreyBeard3D
15
Downloads
13
Likes
0
Makes
Quick Puller attempt. Use an M3 nut and screw. Insert the nut in the space on the inside and partially thread the screw. Slide the puller over the pulley and align the screw with the motor shaft. Tighten the screw and the pulley should come off.
This is untested!
This is untested!
GreyBeard3D publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
